Shrink pots with geometric patterns

Frej Lonnfors happily finds inspiration in popular culture. His shrink pots are often covered with decorative, vibrant patterns carefully cut out with a knife. The patterns on the ten pots he created for Svenskt Tenn are geometric and based on the principles he has developed over many years of craftmanship.

“Many people think that it is the carved lines that make up the pattern itself, but the uncut surfaces are equally important. It is in the interplay between the surfaces and the light that falls on them that everything comes into place.”

To create a shrink pot, the wood must be fresh. Frej fells the birch himself, cuts it up into lengths and stores it outside the workshop. By carving one pot at a time, he avoids excessive drying and cracking. Inside the workshop the craft begins to take shape, as three holes are drilled into the wood. Then the outside of the pot is shaped with an axe and carving knife, and the inside is cut out and cut clean with a gouge.

The base of the pot is carefully shaped. By following the contour of the pot with a pencil, Frej can achieve an exact fit. The material is sawn out with a traditional “grindsåg” saw and the edges are carved clean with a band knife. With a self-made tool he carves out the so-called knot inside the pot. The bottom is fitted to this groove and then the pot is placed on a shelf to dry and shrink so that its walls close in tightly onto the base.

“There is something deeply satisfying when shaping the body of the pot. It’s a hollow vessel that you can present and look at but also hold in your hands.”

Then there is a long period of waiting while the pots dry and shrink and that time is filled with excitement and anticipation.

“It’s impossible to fully know how the different elements will behave during the process. Some birch wood turns a little when drying which gives the pot a slight lengthwise twist. In other cases, the side of a square pot can fall in somewhat resulting in a slightly concave surface. From a craftsman’s perspective I welcome the variations and use them to the pot’s advantage.”

After a few months, the pot has dried and shrunk to its final shape. Then it’s time to make the lid. It is a meticulous process in which a simple technique using flour helps to mark where the seam should be cut. After the lid has been formed and thinned down by carving out the inside, the work is completed using a carving knife.

“I’m constantly chasing the perfect contour of a lid and making small adjustments for every new one I make. Seen from the side, it needs to crown the pot properly. It can’t be too flat, nor too